Product Features:

• Note: This product is an AFG Chassis w/ GeniSys Burner control, PSC Motor, Beckett Ignitor, and Single Stage Beckett Cleanout Pump.
• Air Tubes (different lengths), End Cones (Firing Rates) and Oil Nozzles are sold separately.
• Static Pressure Capability: Enhanced - Medium Range
• Blower Wheel: Special tablock
• Inlet Airflow: Special airguide
• UL Air Tuve Combinations: "F" or "M" Series
• Igniter Gaskets Baseplate/Barrier: Required , always specified
• Low Firing Rate Baffle: Required, per specification
Capacities:
• 0.40 to 3.00 gph
• 56,000 to 420,000 BTU/hr input
Fuels
• No. 1 or No. 2 heating oil (ASTM D396) only
Dimensions (standard)
• Height: 11-1/2"
• Width: 12-7/8"
• Depth: 6-9/16"
• Electrical Characteristics
• Motor: 3450 rpm, NEMA M-flange, manual reset overload protection
• Power Supply: 120 V./60Hz./1 phase
• Ignition: 10,000 V./23 ma. secondary, continuous duty shielded transformer
• Operating Load: 5.8 amps (maximum)
• Alternated Voltages or Frequency: Consult Customer Service
Fuel Unit
• Single stage
Chassis Features
• Nozzle Line Electrode Assembly: Self-centering, delivers oil to the nozzle, high voltage electricity to the electrodes; static plate controls and evens out air flow to the head for smooth, efficient combustion.
• Flame Retention Head: One-piece flame retention burner head. Highly stable and intense combustion increases efficiency by as much as 35 percent.
• Drive Motor: Continuous duty, split phase motor, built for daily hard use and years of trouble-free operation. Overload protection included.
• Blower Wheel: New design provides high static pressure combustion air smoothest starts and combustion under poor draft conditions. Riveted wheel construction for high strength.
• Air Guide: Channels combustion air with exeptional uniformity. Evenly distributes air through blower wheel.